HP PageWide Enterprise Color 765 and MFP 780/785 - Removal and replacement: Inline finisher upper bin moveable tray kit

Follow these steps to remove the inline finisher upper bin moveable tray.

1. Pull the inline finisher upper bin moveable tray all the way out to its extended position.

   Pull the tray out

   

2. Hold the lower fixed portion of the tray, and carefully pull up on the upper removable portion of the tray to release it.

   Release the inner tray

   

3. Remove the upper tray.

   Remove the tray

   

Follow these steps to unpack the replacement assembly.

1. Dispose of the defective part.

   Note:

   HP recommends responsible disposal of the defective part.

   http://www8.hp.com/us/en/hp-information/environment/product-recycling.html

2. Unpack the replacement part from the packaging.

   CAUTION:

   Some parts are sensitive to electrostatic discharge (ESD). Always perform service work at an ESD-protected workstation or mat. If an ESD workstation or mat is not available, touch the sheet-metal chassis to provide a static ground before touching an ESD-sensitive assembly. Protect the ESD-sensitive assemblies by placing them in ESD pouches when they are out of the printer.

   Important:

   Make sure that all of the shipping materials (for example shipping tape) are removed from the replacement part prior to installation.

   Note:

   If the replacement part is a roller or pad, avoid touching the spongy part of it. Skin oils on the roller or pad can cause paper pickup and/or print-quality problems. HP recommends using disposable gloves when handling rollers or pads or washing your hands before touching rollers or pads.

3. To install an assembly, reverse the removal steps.

   Note:

   When applicable, special installation instructions are provided for an assembly at the end of the removal procedure. Always completely read the removal instructions and follow all special installation instructions.

Follow these steps to install the inline finisher upper bin moveable tray.

1. Align the ribs on the bottom of the replacement upper tray with the slots in the lower tray.

   Note:

   Make sure that the tab on the upper tray is installed in the slot in the lower tray.

   Install the tray (1 of 2)

   

2. Lower the upper tray onto the lower tray (press down to snap the trays together).

   Install the tray (2 of 2)

   

3. Make sure that the upper tray is fully seated on the lower tray. The upper tray must fit completely over the lower tray (as shown, left below).

   Verify tray installation

   

4. Push the tray back into is recessed position.

   Push the tray back in